Monday, December 26, 2011

T+A S10 Stereo Power Amplifier










































NOK 115,000

Pre-amplifiers can be connected using Cinch / RCA, XLR 3-pole or XLR 4-pole plugs.

The S 10 features two identical output stages, each of which is connected to a pair of the latest High-End loudspeaker terminals (WBT nextgenTM). Speaker cables with any kinds of spades or plugs can be used to connect the loudspeakers. Moving the left slide-switch to High Current doubles the idle current. In this mode an output of up to thirtyfive Watts is possible in pure Class A mode! In the downwards position the full operating voltage is used and the S 10 works in High Power Mode.

All V-Series Models are controlled by the R-Link Data Bus System. The P10  controls the entire system via the R-Link data bus, including switching all components on and off.

Specifications

High Power Mode
Nominal Power* 8 Ohm 2 x 320 Watts
Nominal Power* 4 Ohm 2 x 500 Watts
Peak Power* 8 Ohm 2 x 380 Watts
Peak Power* 4 Ohm 2 x 700 Watts

High Current Mode
Up to 35 Watts pure Class A mode
Up to 140 Watts in Class A/B mode
* Umains = 240V (230 V - Version)
* Umains = 120V (115 V - Version)
Per channel both channels driven

Frequency response (0 - -3dB) 1 Hz - 150 kHz
Slew rate 65 V / µs
Damping factor 4 Ohm > 65
Signal / noise ratio > 113 dB
Total harmonic distortion (5 W, 4 Ohm, 1 kHz) < 0,03 %
Inputs Cinch / RCA, XLR 3pin, XLR 4pin

PWR-Supply reservoir capacity 180000 µF
PWR requirement 110 - 120 V / 50 - 60 Hz or 1800 Watts
220 - 240 V / 50 - 60 Hz

Dimensions (H x W x D) 52 x 35 x 48 cm
Weight 51 kg

Available finishes Silver aluminium, Titanium acrylic glass alternatively in grey or blue
Remote control via P 10 or R-System

If you set the target attribute to "_blank", the link will open in a new browser window or a new tab.